P 40 series panels are a rugged, dependable solution for mechanical (non-ECU) engine or pump fault monitoring and protection. Their compact size and ease of installation make these panels highly suited to mobile or stationary engine-driven applications such as earth moving equipment and pumps.

The P60 panel provide manual start/stop and automatic fault protection for generators, pumps and other engine-driven applications. Operator control is by a 4 position keyswitch, with the key removable only in the Stop/Reset (O) position. Outputs allow control of engine fuel (energized to run), starter motor and preheat. The Keystart also has an alarm output for remote or audible warning of faults.

The Panel P100 provides operator-controlled start/stop, and automatic fault shutdown and indication for mechanical (non- ECU) engines. The panels are primarily used in stationary engine applications such as pumps, crushers, shredders, etc. Operator control is through a 3 position key switch on a Murphy Keystart module. The key is common to all Keystart’s and is removable only in the Stop/Reset (O) position. A P100FS (Failsafe Keystart) is also available for order.

The P200 panel incorporates a PowerView 485 which is a customizable, all-in-one color display and controller designed to meet the needs of modern electronic engines and equipment applications. Its rugged design offers a wide array of configurable I/O and supports both mechanical and J1939 electronic engines.

The ECS P410 Panel, engineered and built by ECS, is a superior panel offering which includes the powerful, yet simple-to-configure MPC-10 Controller. The MPC-10 is a general, all-purpose manual/auto start and manual/auto throttling engine controller designed with rental applications in mind. The controller is purposed primarily for applications where a wide array of inputs and outputs are not required.

P500 series panels are rugged, dependable solution for mechanical (non-ECU) engine or pump fault monitoring and protection. Their compact size and ease of installation make these panels highly suited to mobile or stationary engine-driven applications such as tractors, PTO devices, earth moving equipment and pumps.

The P800 panel provides operator controlled start and stop of the unit. Automatic shutdown protection in the event of a fault on both the engine and the air end. Operator control is via an on/off switch and a bypass button. The bypass button opens the shutdown circuit for the operator to start and build up engine oil pressure. When the engine is running the bypass button can be released to activate the safety circuit.

The P900 panels were developed for air cooled and liquid cooled engines powering truck mounted mobile drill rigs. Both panels feature Swichgage protection for low oil pressure and high engine temperature. Panel P900 A is a warning only panel with no shut down. Panel P900 B incorporates a Murphy Keystart module for shut down on low oil pressure and high engine temperature. A P900 BFS panel is also available with a failsafe Keystart, should a wire come off or tampered with, it will shut down. Either of these panels can be ordered with or without the 220VAC plug and Hertz meter depending if the drill rig has an onboard welder present. All emergency stop buttons can be incorporated into the P900 B for safety shut down if required by the site of operation. Both panels are supplied with a complete wiring harness and connectors.